Flowpoint and Efficient Routers are setup with Network Address Translation. NAT allows many computers to access the Internet by masking behind one IP address while protecting the local area network from possible hostile intrusions via external networks. This serves as a basic firewall while still allowing general Internet use. With the default configuration, up to 254 hosts can be connected to the router.

• NAT enabled
• Router LAN IP address: 192.168.254.254
• Subnet Mask: 255.255.255.0

• A CAT 5 Ethernet cable or a Console Cable.
• A computer with a 10BaseT or 10/100BaseT Network Interface Card that is properly installed.
• A terminal emulation program such as Microsoft Windows Telnet or Hyperterminal
• A Web browser such as Internet Explorer or Navigator.
• The router must be physically connected to the DSL line.

Open a telnet client (Hyperterminal, Secure CRT, etc.) and telnet to 192.168.254.254. This will display Login: with a cursor next to it. The login is the password of the router. The default password is admin. Type this in and hit Enter. If the correct password was entered it will display Logged in successfully! with a pound (#) sign underneath it. Enter in all commands, as displayed below, after the pound sign. Remember to hit Enter after every line.

These lines must typed in exactly as shown below, with an exception for the information listed in RED. All information listed in RED is specific to your line. Be sure to press Enter at the end of every line.

rem add internet
rem setprotocol rfc1483 internet
rem setpvc 0*35 internet
rem setsrcipaddr YOUR IP ADDRESS 255.255.255.0 internet
rem setrmtipaddr YOUR DEFAULT GATEWAY 255.255.255.0 internet
rem addiproute 0.0.0.0 255.255.255.255 1 internet
rem setiptrans on internet

dhcp set valueoption domainnameserver 209.145.150.10 209.145.176.20
dhcp set valueoption domainname accessus.net

save
reboot